please help,
anyone knows about this ? will it apply to smith & wesson ppk/s in thailand ?
IMPORTANT SAFETY RECALL NOTICE - February 20, 2009
PRODUCT:
Walther PPK and PPK/S pistols
DESCRIPTION OF THE HAZARD:
Smith & Wesson has identified a condition that may exist in certain PPK and PPK/S pistols which may permit a round to be discharged without the trigger being pulled. When the manual safety is disengaged, Smith & Wessons Product Engineering Group has determined that the possibility exists in certain firearms that lowering the hammer may cause a chambered round to fire.
DESCRIPTION OF THE PRODUCT INVOLVED:
This recall applies to all Walther PPK and PPK/S pistols manufactured by Smith & Wesson from March 21, 2002, until February 3, 2009. The Serial Numbers of the pistol subject to this recall are as follows:
BAB 0010-BAB 9999
BAC 0000-BAC 9999
BAD 0000-BAD 9999
LTD 0000-LTD 0499
PPK 0001-PPK 1500
BAE 0000-BAE 9999
BAF 0000-BAF 9999
WLE 0001-WLE 0459
BAH 0000-BAH 9999
BAJ 0000-BAJ 9999
BAK 0000-BAK 9999
REP 0026-REP 0219
BAL 0000-BAL 5313
BAM 0000-BAM 1320
REMEDY/ACTION TO BE TAKEN:
STOP USING YOUR PISTOL AND RETURN IT TO SMITH & WESSON AT ONCE.
Any unintended discharge of a firearm has the potential for causing injury, and we ask that you stop using your pistol immediately.
To facilitate the repair of your pistol, please contact Smith & Wesson's customer service department to receive instructions for the return of your pistol to Smith & Wesson.
When you return your pistol to Smith & Wesson, we will replace the existing hammer block feature with a new part at no cost to you. Your firearm will be returned as quickly and efficiently as possible.
VERIFICATION OF CORRECTIVE ACTION:
When your pistol is returned, you should note a punch dot which appears at the back of the frame. See the photograph below.
This marking is verification that the new hammer block has been installed and that your pistol is safe to handle.
CONSUMER CONTACT:
To receive a UPS pre-paid billable stamp and shipping instructions to arrange for the modification of your pistol click here or contact Smith & Wesson directly at 1-800-331-0852.
IF YOU HAVE ANY QUESTIONS ABOUT THIS RECALL, PLEASE CONTACT SMITH & WESSON AT
1-800-331-0852 or email us at
PPK_S@smith-wesson.com.
Privacy Legal Site Map Dealer Resources Contact Us Walther America ©2009 Smith & Wesson. All Rights Reserved.
